Control systems

Control boxes provide a plug-and-play method of controlling our linear actuators.MPP manufactures high quality linear actuator systems and offers a wide range of control boxes to support our products. All our wireless control boxes come with a wiring harness and a wired or wireless handheld remote for easy and quick setup. A variety of power input options are available, allowing AC input and DC output, or direct DC voltage input.
12-24 V control kit for linear actuator 12-24 V control kit for linear actuator 2
Expedition sous 24h
Control systems

12-24 V control kit for linear actuator

MPP-CS22-A
€49.00
Remote control box for electric cylinder or linear actuator. This kit which connects to a 12v or 24 V power source (car/boat battery, etc.) will allow you to control your electric actuator. Very easy installation, two plus and minus wires connected at the input and two at the output for the electric cylinder.
12-24 V control kit for two electric linear actuators 12-24 V control kit for two electric linear actuators 2
Expedition sous 24h
€55.00
Remote control box for electric cylinder or linear actuator. This kit which connects to a 12v or 24 V power source (car/boat battery, etc.) will allow you to control your electric actuator. Very easy installation, two plus and minus wires connected at the input and two at the output for the electric cylinder.
Alimentation Vérins Alimentation Vérins 2
Expédition en 24h
This all-in-one control kit will allow you to connect your 12V electric actuator directly to a standard 220 V AC electrical outlet. Current: 2A (max 7A) Short circuit protection. Compatible only with the following 12 volt actuators: MPP-EC-12v MPP-ECH-12V MPP-MD-12V
Power supply and control KIT for two linear actuaors Power supply and control KIT for two linear actuaors 2
Expedition sous 72h
Alimentations électriques

Power supply and control KIT for two linear actuaors

MPP-AL2
€79.90
This complete all-in-one control kit will allow you to connect your 12V electric actuator directly to a standard 220 V AC electrical outlet. It will allow you to connect two 12 volt actuators to a 220V socket and control them one by one but also both at the same time. However, synchronization is not guaranteed and, depending on the jacks, offsets of plus...
Synchronization systems of two hall sensor actuators
Expédition sous 15 jours
€299.00
This control box allows 100% synchronized control  of two Hall effect actuators. The control box comes with all hardware required for wireless operation, including two FCC-approved wireless remote controls with momentary and non-momentary motion control capabilities. Please note that this control box is only compatible with a pair of hall effect actuators...
Box for synchronization of four hall effect actuators Box for synchronization of four hall effect actuators 2
Expédition sous 15 jours
€399.00
This control box allows 100% synchronized control  of four Hall effect electric actuators. The control box comes with all hardware required for wireless operation. Two FCC-approved wireless remote controls with momentary and non-momentary motion control capabilities. Please note that this control box is only compatible with actuators with Hall effect...
Rocker Switch - Momentary 20A
En stock
mounting brackets

Rocker Switch - Momentary 20A

MPP-RS1
€14.92
This rocker switch is ideal to control linear actuators at a low cost. It is available in two models, one with momentary and one with non-momentary functionality. The momentary switch is spring-loaded, just press a button to extend or retract actuator. When the button is released the switch will spring back to off position.
ac/dc adapter SP2A
En stock
Alimentations électriques

ac/dc adapter SP2A

MPP-AD
€49.90
24V adapter compatible with the MPP-BT battery. Compatible with 24 V IQ and TW actuators in 24 V.
Spare remote control MPP Spare remote control MPP 2
En stock
Control systems

Spare remote control MPP

MPP-TEL
€29.00
Replacement remote control for the MPP-AL1, Mpp-AL2 and MPP-CS1 Kit. Available in two buttons or six buttons.
Smart DC motor controller Smart DC motor controller 2
15 jours
Control systems

Smart DC motor controller

Mpp-SC-PLI
€99.00
Supply voltage 10 → 35 Vdc Running 15A Tension 12 VDC; 24 VDC Compatible engine type permanent magnet control input Potentiometer, Voltage Assembly Panel Mount, DIN Rail Mount Length 72mm Lenght 25mm Depth 42mm Dimensions 72 x 25 x 42mm Operating temperature range -40 → +60°C
RSP-320-24 320W Integrated Switching Power Supply
En stock
Alimentations électriques

RSP-320-24 320W Integrated Switching Power Supply

RSP-320-24
€61.00
Mean Well Switch Mode Power Supply The Mean Well RSP-320 Integrated AC/DC Switching Power Supply single output 321.6 W is rated at 13.4 A output at 24 VDC. It has a universal input supply voltage of 88 to 264 VAC and 124 to 370 VDC Power supply is 40% smaller than corresponding models. The ambient temperature ranges from 30°C and 50°C under full load...
Bluetooth dongle/EM-326 Bluetooth dongle/EM-326 2
15 jours
Control systems

Bluetooth dongle/EM-326

Mpp-DO-EM326
€79.00
E The C2-Bluetooth dongle/EM-326 is used to set the parameters of C2 products (C2-20, C2-30, etc.) with the phone. It can be used in the same way as the C2-PROG/EM-236 and C2-PROG/EM-268. Connect it to a product using the red connector. The Ementool app is available for free in the App Store.
Product added to wishlist
Product added to compare.

Ce site utilise les cookies.